Ad
related to: fluid booster pump for water
Search results
Results From The WOW.Com Content Network
Small compressed air powered breathing gas booster pump Haskell booster set up for charging rebreather cylinders from premix banks with low pressure compressor. A booster pump is a machine which increases the pressure of a fluid. It may be used with liquids or gases, and the construction details vary depending on the fluid.
The device uses the water hammer effect to develop pressure that allows a portion of the input water that powers the pump to be lifted to a point higher than where the water originally started. The hydraulic ram is sometimes used in remote areas, where there is both a source of low-head hydropower and a need for pumping water to a destination ...
The water hammer principle can be used to create a simple water pump called a hydraulic ram. Leaks can sometimes be detected using water hammer. Enclosed air pockets can be detected in pipelines. The water hammer from a liquid jet created by a collapsing microcavity is studied for potential applications noninvasive transdermal drug delivery. [33]
A small, electrically powered pump A large, electrically driven pump for waterworks near the Hengsteysee, Germany. A pump is a device that moves fluids (liquids or gases), or sometimes slurries, [1] by mechanical action, typically converted from electrical energy into hydraulic or pneumatic energy.
Warman centrifugal pump in a coal preparation plant application A pair of centrifugal pumps for circulating hot water within a hydronic heating system. Centrifugal pumps are used to transport fluids by the conversion of rotational kinetic energy to the hydrodynamic energy of the fluid flow. The rotational energy typically comes from an engine ...
Fluid Equipment Development Company (FEDCO) is a Michigan-based designer and manufacturer of high-pressure feed pumps and brine energy recovery devices (ERDs) for brackish water reverse osmosis (BWRO) and seawater reverse osmosis (SWRO) systems. With over 3,500 units in service, FEDCO pumps and ERDs can be found on 6 continents, specifically in ...
This avoids one of the principal challenges faced by the larger, two-part pumps: maintaining a water-tight seal at the point where the pump drive shaft enters the pump body. Small- to medium-sized circulator pumps are usually supported entirely by the pipe flanges that join them to the rest of the hydronic plumbing. Large pumps are usually pad ...
Fluid flow in an external gear pump. A hydraulic pump is a mechanical source of power that converts mechanical power into hydraulic energy (hydrostatic energy i.e. flow, pressure). Hydraulic pumps are used in hydraulic drive systems and can be hydrostatic or hydrodynamic. They generate flow with enough power to overcome pressure induced by a ...