When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Cooling load temperature difference calculation method

   en.wikipedia.org/wiki/Cooling_load_temperature...

   The first of the cooling load factors used in this method is the CLTD, or the Cooling Load Temperature Difference. This factor is used to represent the temperature difference between indoor and outdoor air with the inclusion of the heating effects of solar radiation. [1] [5] The second factor is the CLF, or the cooling load factor.

3. Wrightsoft - Wikipedia

   en.wikipedia.org/wiki/Wrightsoft

   As the original technical software partner of ACCA, [3] Wrightsoft Corp became the first HVAC software company to create a computerized version of their Manual J, Manual D, and Manual N calculation methods. The Air Conditioning Contractors of America and Wrightsoft released the very first Manual J Load calculation software (Right-J) in February ...

4. Sol-air temperature - Wikipedia

   en.wikipedia.org/wiki/Sol-air_temperature

   Sol-air temperature (T sol-air) is a variable used to calculate cooling load of a building and determine the total heat gain through exterior surfaces. It is an improvement over: = Where: = rate of heat transfer [W] = heat transfer surface area [m 2]

5. Cooling load - Wikipedia

   en.wikipedia.org/wiki/Cooling_load

   The cooling load [3] is calculated to select HVAC equipment that has the appropriate cooling capacity to remove heat from the zone. A zone is typically defined as an area with similar heat gains, similar temperature and humidity control requirements, or an enclosed space within a building with the purpose to monitor and control the zone's temperature and humidity with a single sensor e.g ...

6. CFD in buildings - Wikipedia

   en.wikipedia.org/wiki/CFD_in_buildings

   External and internal environment of buildings: wind loading, ventilation analysis and heating/cooling load calculations. Previously, most building-related issues such as ventilation analysis, wind loading, wind environment etc. were examined using wind tunnel tests, but today all these tests can be done effectively with CFD.

7. Thermostat - Wikipedia

   en.wikipedia.org/wiki/Thermostat

   Heat pumps therefore have a provision for occasional defrost of the outdoor coil. This is done by reversing the cycle to the cooling mode, shutting off the outdoor fan, and energizing the electric heating elements. The electric heat in defrost mode is needed to keep the system from blowing cold air inside the building.