Ads
related to: exact time to the seconds
Search results
Results From The WOW.Com Content Network
The second (symbol: s) is a unit of time, historically defined as 1 ⁄ 86400 of a day – this factor derived from the division of the day first into 24 hours, then to 60 minutes and finally to 60 seconds each (24 × 60 × 60 = 86400).
The exact modern SI definition is "[The second] is defined by taking the fixed numerical value of the cesium frequency, Δν Cs, the unperturbed ground-state hyperfine transition frequency of the cesium 133 atom, to be 9 192 631 770 when expressed in the unit Hz, which is equal to s −1."
Contrary to TAI, UTC is a discontinuous time scale. It is occasionally adjusted by leap seconds. Between these adjustments, it is composed of segments that are mapped to atomic time by a constant offset. From its beginning in 1961 through December 1971, the adjustments were made regularly in fractional leap seconds so that UTC approximated UT2.
In the International System of Units (SI), the unit of time is the second (symbol: s). It has been defined since 1967 as "the duration of 9 192 631 770 periods of the radiation corresponding to the transition between the two hyperfine levels of the ground state of the caesium 133 atom", and is an SI base unit. [12]
Metric time is the measure of time intervals using the metric system. The modern SI system defines the second as the base unit of time, and forms multiples and submultiples with metric prefixes such as kiloseconds and milliseconds. Other units of time – minute, hour, and day – are accepted for use with SI, but are not part of it
Screenshot of the UTC clock from time.gov during the leap second on 31 December 2016.. A leap second is a one-second adjustment that is occasionally applied to Coordinated Universal Time (UTC), to accommodate the difference between precise time (International Atomic Time (TAI), as measured by atomic clocks) and imprecise observed solar time (), which varies due to irregularities and long-term ...
The time is announced every 10 seconds and alternates between English and Afrikaans languages. An example of an English announcement of the time would be: "When you hear the signal, it will be four hours, fifteen minutes and ten seconds", followed by a short audible tone to signal the exact time previously announced.
Unix time numbers are repeated in the second immediately following a positive leap second. The Unix time number 1 483 228 800 is thus ambiguous: it can refer either to start of the leap second (2016-12-31 23:59:60) or the end of it, one second later (2017-01-01 00:00:00). In the theoretical case when a negative leap second occurs, no ambiguity ...