Search results
Results From The WOW.Com Content Network
Where a blend door is used instead of a control valve as a method of controlling the air's heating amount, the door itself or its control mechanism can become stuck due to thermal expansion. If the climate control unit is automatic, actuators can also fail. Another possible problem is a leak in one of the connections to the heater core.
When the engine is cool or even at normal operating temperature, the fan clutch partially disengages the engine's mechanically driven radiator cooling fan, generally located at the front of the water pump and driven by a belt and pulley connected to the engine's crankshaft. This saves power, since the engine does not have to fully drive the fan.
Radiator caps for pressurized automotive cooling systems. Of the two valves, one prevents the creation of a vacuum, the other limits the pressure. It is generally a limitation of most cooling systems that the cooling fluid not be allowed to boil, as the need to handle gas in the flow greatly complicates design.
At the time, warming the car in the winter made sense since it could take several minutes for the right air-fuel mix to reach the engine, without which the vehicle was at risk of stalling or ...
A larger bypass is often provided, through the cylinder block and water pump, so as to keep the rising temperature distribution even. [5] Work on cooling high-performance aircraft engines in the 1930s led to the adoption of pressurised cooling systems, which became common on post-war cars. As the boiling point of water increases with increasing ...
For water-cooled engines on aircraft and surface vehicles, waste heat is transferred from a closed loop of water pumped through the engine to the surrounding atmosphere by a radiator. Water has a higher heat capacity than air, and can thus move heat more quickly away from the engine, but a radiator and pumping system add weight, complexity, and ...
For premium support please call: 800-290-4726 more ways to reach us
A working system should not generate further trapped gas. Air may be drawn in if there is a small leak, or dissolved air in make-up water may come out of solution, but this generally indicates a system leak if new water is needing to be added. The most likely cause of continual gas bleeding is hydrogen, rather than air. [2]