Search results
Results From The WOW.Com Content Network
An electromagnetic relay with a pair of contacts. An electrical contact is an electrical circuit component found in electrical switches, relays, connectors and circuit breakers. [1]
Schematic diagram of a copper–zinc voltaic pile. Each copper–zinc pair had a spacer in the middle, made of cardboard or felt soaked in salt water (the electrolyte). Volta's original piles contained an additional zinc disk at the bottom, and an additional copper disk at the top; these were later shown to be unnece
The signal relay in question was switched only on the hot side, while the return current came back on an unswitched wire. A loose wire bypassed the contacts by which the train detection relays switched the signal, allowing the signal to show green when in fact there was a stationary train ahead. 35 people were killed in the resultant collision.
A break junction is an electronic device which consists of two metal wires separated by a very thin gap, on the order of the inter-atomic spacing (less than a nanometer). This can be done by physically pulling the wires apart or through chemical etching or electromigration . [ 1 ]
Break in the shield Create a break in the signal cable shield conductor. [5] The break should be at the load end. This is often called ground lifting. It is the simplest solution; it leaves the ground currents to flow through the other arm of the loop. Some sound system components have ground lifting switches at inputs, which disconnect the ground.
Fandom [a] (formerly known as Wikicities and Wikia) [b] is a wiki hosting service that hosts wikis mainly on entertainment topics (i.e., video games, TV series, movies, entertainers, etc.). [9]
Ancient Japanese iron kaginawa climbing hook A chain grapnel – used to recover a cable from the seabed. A grappling hook or grapnel is a device that typically has multiple hooks (known as claws or flukes) attached to a rope or cable; it is thrown, dropped, sunk, projected, or fastened directly by hand to where at least one hook may catch and hold on to objects.
Wire removal is a visual effects technique used to remove wires in films, where the wires are originally included as a safety precaution or to simulate flying in actors or miniatures. It uses a lot of rotomatting, a process of using splines in a program like After Effects or Nuke to extract a subject from a video, motion tracking, and painting ...