Ads
related to: convert 2 meters to inches to feet calculator chart
Search results
Results From The WOW.Com Content Network
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
The foot (standard symbol: ft) [1][2] is a unit of length in the British imperial and United States customary systems of measurement. The prime symbol, ′, is commonly used to represent the foot. [3] In both customary and imperial units, one foot comprises 12 inches, and one yard comprises three feet. Since an international agreement in 1959 ...
The basic unit of length in the imperial and U.S. customary systems is the yard, defined as exactly 0.9144 m by international treaty in 1959. [2] [5] Common imperial units and U.S. customary units of length include: [6] thou or mil (1 ⁄ 1000 of an inch) inch (25.4 mm) foot (12 inches, 0.3048 m) yard (3 feet, 0.9144 m)
The board foot or board-foot is a unit of measurement for the volume of lumber in the United States and Canada. It equals the volume of a board that is one foot (30.5 cm) in length, one foot (30.5 cm) in width, and one inch (2.54 cm) in thickness, or exactly 2.359 737 216 liters. Board foot can be abbreviated as FBM (for "foot, board measure ...
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...
The United States adopted the conversion factor 1 metre = 39.37 inches by an act in 1866. [30] In 1893, Mendenhall ordered the physical realization of the inch to be based on the international prototype metres numbers 21 and 27, which had been received from the CGPM, together with the previously adopted conversion factor. [31]
In aviation, pressure altitude is the height above a standard datum plane (SDP), which is a theoretical level where the weight of the atmosphere is 29.921 inches of mercury (1,013.2 mbar; 14.696 psi) as measured by a barometer. [2] It indicates altitude obtained when an altimeter is set to an agreed baseline pressure under certain circumstances ...
Sv. ≡ 1 J/kg [44] = 1 Sv = 1 J/kg = 1 m 2 ⋅s 2. Although the definitions for sievert (Sv) and gray (Gy) would seem to indicate that they measure the same quantities, this is not the case. The effect of receiving a certain dose of radiation (given as Gy) is variable and depends on many factors, thus a new unit was needed to denote the ...