Search results
Results From The WOW.Com Content Network
A type of ball and socket joint called a "torque ball" is used at one end of the torque tube to allow relative motion between the axle and transmission due to suspension travel. Later American Motors Rambler models (1962 through 1966) used a flange and cushion mount in place of the ball and socket. [5]
A driveshaft coupling. Note the split damage beginning to appear, likely due to the large axial displacement. A giubo. A giubo (/ ˈ dʒ uː b oʊ / JOO-boh; etymology: giunto Boschi, "Boschi joint"), also known as a 'flexdisc', and sometimes misspelled as guibo, is a flexible coupling used to transmit rotational torque between the drive shaft and the companion flange on mechanical devices ...
A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...
The torque tube surrounded the true driveshaft and exerted the force to its ball joint at the extreme rear of the transmission, which was attached to the engine. A similar method like this was used in the late 1930s by Buick and by Hudson 's bathtub car in 1948, which used helical springs that could not take fore-and-aft thrust.
The book says that the road safety mantra called the "Three E's" ("Engineering, Enforcement and Education") was created by the industry in the 1920s to distract attention from the real problems of vehicle safety, such as the fact that some were sold with tires that could not bear the weight of a fully loaded vehicle.
In newer designs, a ball joint at each end allows for all movement. Attached to the knuckle at its center is a bearing hub, or in many older designs, a spindle to which the wheel bearings are mounted. To resist fore-aft loads such as acceleration and braking, the arms require two bushings or ball joints at the body.
The two arms, the spindle, and the body, form a four-bar link.Use of the linkage at the lower suspension connection of either a MacPherson strut or a short long arms suspension readily gives an effective virtual ball joint outboard of the spindle, which is very useful for a suspension designer, allowing negative scrub radius whilst allowing the ball joints to move in and thus out of the way of ...
Recirculating ball, also known as recirculating ball and nut or worm and sector, is a steering mechanism commonly found in older automobiles, off-road vehicles, and some trucks. Most newer cars use the more economical rack and pinion steering instead, but some upmarket manufacturers (such as BMW and Mercedes-Benz ) held on to the design until ...