Ads
related to: simple board and batten wall treatment design
Search results
Results From The WOW.Com Content Network
Here, the boards and batten extend six feet high on a nine-foot wall. See more at Christene Holder Home » RELATED: 5 Ways You're Ruining Your Accent Wall, According to Designers
Box houses (boxed house, box frame, [16] box and strip, [17] piano box, single-wall, board and batten, and many other names) have minimal framing in the corners and widely spaced in the exterior walls, but like the vertical plank wall houses, the vertical boards are structural. [18] The origins of boxed construction is unknown.
The hashira-ma might be filled with fixed walls, in cheaper Japanese homes. For example, there might be lath-and-plaster walls, or in colder areas thatch walls; these are still used in rustic teahouses and historic buildings (see images). Bark-and-bamboo walls, clapboard, and board-and-batten walls were also used. [91]
The term is used with buildings and non-building structures to identify when a wall or element is intentionally built with an inward slope. A battered corner is an architectural feature using batters. A batter is sometimes used in foundations, retaining walls, dry stone walls, dams, lighthouses, and fortifications. Other terms that may be used ...
In architecture, the dado is the lower part of a wall, [1] below the dado rail and above the skirting board. The word is borrowed from Italian meaning "dice" or "cube", [ 2 ] and refers to " die ", an architectural term for the middle section of a pedestal or plinth .
Lime or gypsum plaster is then applied, typically using a wooden board as the application tool. The applier drags the board upward over the wall, forcing the plaster into the gaps between the lath and leaving a layer on the front the depth of the temporary guides, typically about 1 ⁄ 4 inch (6.4 mm). A helper feeds new plaster onto the board ...
Batter boards (or battre boards, Sometimes mispronounced as "battle boads") are temporary frames, set beyond the corners of a planned foundation at precise elevations. These batter boards [ 1 ] are then used to hold layout lines (construction twine) to indicate the limits [ 2 ] (edges and corners) of the foundation.
A time-honored method of hanging a drop is the roll-drop, in which the bottom of the drop is attached to a round batten. The drop is rolled onto it from the back, and is deployed by rope rigged through blocks (pulleys) to be pulled from offstage to release the tension holding the batten up, thus unrolling it slowly until completely unfurled.