Search results
Results From The WOW.Com Content Network
Other problems may be implicated in the case of older vehicles equipped with carburetors. Weak, disconnected, or mis-connected throttle return springs, worn shot-pump barrels, chafed bowden cable housings, and cables which jump their tracks in the throttle-body crank can all cause similar acceleration problems.
Number 1 is the differential housing. Numbers 3 are the optional radius arms. Number 4 is the torque ball. A torque tube system is a power transmission and braking technology that involves a stationary housing around the drive shaft, often used in automobiles with a front engine and rear
A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...
The number of vehicles likely to be affected in Europe was unconfirmed but Toyota said it may reach up to 1.8 million. [7] At the time of recall there had been 30 incidents involving the accelerator pedal problem in Europe. [72] The vehicles affected in Europe are: [72] Feb 2005 – Aug 2009 Toyota Aygo (automatic models only [73])
Vehicles that commonly experience suspension loads heavier than normal, have heavy or hard springs, with a spring rate close to the upper limit for that vehicle's weight. This allows the vehicle to perform properly under a heavy load, when control is limited by the inertia of the load. Riding in an empty truck meant for carrying loads can be ...
English: Front right wheel of a Mercedes Vito utility van. The unusual angle is due to a ball joint failure - probably resulting from hitting a kerb too hard. The ball joint (dark protrusion at the outer tip of the lower control arm, by the tire sidewall) is no longer attached to the knuckle.
The two arms, the spindle, and the body, form a four-bar link.Use of the linkage at the lower suspension connection of either a MacPherson strut or a short long arms suspension readily gives an effective virtual ball joint outboard of the spindle, which is very useful for a suspension designer, allowing negative scrub radius whilst allowing the ball joints to move in and thus out of the way of ...
In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension. The four-bar linkage mechanism formed by the unequal arm lengths causes a change in the camber of the vehicle as it rolls, which helps to keep the contact patch square on the ground, increasing the ultimate cornering capacity of the vehicle. It also ...