Search results
Results From The WOW.Com Content Network
Twin-Traction Beam was invented by John A. Richardson and Donald G. Wheatley of Ford Motor Company covered by US patent 3,948,337 issued April 6, 1976. The patent name was “Independent front suspension for front-wheel drive” which was assigned to Ford Motor Company. [1] [2] The Dana Holding Corporation manufactured
The 2022 Ford Bronco Raptor utilizes an AdvanTEK M235 (not Dana 50) solid rear axle with a 235mm (9.25 in) ring gear and electronic locking differential. The ratio is 4.70:1. [2] The 2023+ Ford Super Duty F-250 and F-350 come equipped with the Dana Advantek M235 (not Dana 50) front axle in high pinion configuration.
All F-450 and F-550 chassis-cab trucks used a solid front axle, and on 4×4 models, the Dana 60 front axle was replaced with a Dana Super 60 for 2005. The leaf springs were also changed to coil springs for 2005. 2008–2010 and 2015–2018 F-450 pickups used Dana S 110 rear axles, while 2011–2014 F-450 pickups used Dana 80 axles.
GM began making 4x4 Chevrolet Kodiaks and GMC Topkicks that utilize a Dana 70 front axle for the 2005-2009 models. These Dana 70 axles had open knuckles and ball joints . The Dana 70 axle only came with 5.13:1, 4.88,5.31 [ citation needed ] gear ratios and had a GAWR of [ citation needed ] these axles were rated at 7-9klbs as seen on 5500 door ...
The F-150 4×4 continued the use of the Dana 44 Twin-Traction Beam axle from the 1980–1991 trucks, and the Ford 8.8" rear straight axle. The 4×4 F-250 carried the Dana 50 Twin Traction Beam axle, the Sterling 10.25 from the previous generation for the rear; full-float on the F-250 HD and the 4×4 F-350 used the Dana 60 front straight axle ...
For model year 2000 - 2004 trucks, the F-150 7700 offered this axle and the F-250 light duty was discontinued. At least till 2011 the 12 bolt semi float was still found with the heavy duty f-150. Gear ratios were 3.73 in 4x4 and either the 3.73 or 4.10 in the two-wheel-drive models. This was available in both limited slip and standard variations.
The Dana 61 was made in semi-float and full-float axles for select 4×2 and 4x4 Ford 3 ⁄ 4-ton and 1 Ton Pickups and Vans from 1974 to 1987. A Dana 61 front axle was selectively used in Dodge 4×4 3 ⁄ 4-ton and 1 Ton pickups from 1987 to 1993. Although 3.07:1 and 3.31:1 gear sets are common for a Dana 61, lower gear sets deeper than (4.10:1 ...
The Dana 44 Front axle first saw use in the 1950s and still in use today. Dana 44 Front axles were known for utilizing locking hubs or a center axle disconnect system. However, a permanently locked-in Dana 44 is not uncommon. The Dana 44 has seen use in 1/4-, 1/2-, 3/4-, and 1-ton rated trucks.