Ads
related to: flexible duct maximum length limit required
Search results
Results From The WOW.Com Content Network
There are two major systems to classify ductwork airtightness, one based on European standards, the other based on ASHRAE standard 90.1-2010.Both are based on the leakage airflow rate at a given ductwork pressure divided by the product of the ductwork surface area and the same ductwork pressure raised to the power 0.65.
A duct with less than 0.75 mg/100m 2 is considered to be clean, per the NADCA standard. [7] A Hong Kong standard lists surface deposit limits of 1g/m 2 for supply and return ducts and 6g/m 2 for exhaust ducts, or a maximum deposit thickness of 60 μm in supply and return ducts, and 180 μm for exhaust ducts. [8]
Microducts are typically small-diameter, flexible, or semi-flexible ducts designed to provide clean, continuous, low-friction paths for placing optical cables that have relatively low pulling tension limits. As stated in industry requirements document Telcordia GR-3155 [1] Generic Requirements for Microducts for Fiber Optic Cables, microduct ...
The stiffeners are usually considered pinned end. Power plant ductwork can be 5/16" thick duct plate, with "fixed end" W stiffeners at roughly 2'-5" spacing. Because rectangular duct plate bends, stiffeners are required at reasonably close spacing. Duct plate 3/16", or thinner, may dishpan, or make noise, and should be avoided.
The viscous friction causes the flow properties to change along the duct. The frictional effect is modeled as a shear stress at the wall acting on the fluid with uniform properties over any cross section of the duct. For a flow with an upstream Mach number greater than 1.0 in a sufficiently long duct, deceleration occurs and the flow can become ...
Liquidtight flexible metal conduit (LFMC) is a metallic flexible conduit covered by a waterproof plastic coating. The interior is similar to FMC. The interior is similar to FMC. Flexible metallic tubing ( FMT ; North America ) is not the same as flexible metallic conduit (FMC) which is described in US National Electrical Code (NEC) Article 348.