Ad
related to: ball joint failure on highway vehicle safety system
Search results
Results From The WOW.Com Content Network
Systematic motor-vehicle safety efforts began during the 1960s. In 1960, unintentional injuries caused 93,803 deaths; [5] 41% were associated with motor-vehicle crashes. In 1966, after Congress and the general public had become thoroughly horrified by five years of skyrocketing motor-vehicle-related fatality rates, the enactment of the Highway Safety Act created the National Highway Safety ...
A typical ball joint with cutaway view (right) An inner tie rod end cut open to expose the ball joint. In an automobile, ball joints are spherical bearings that connect the control arms to the steering knuckles, and are used on virtually every automobile made. [1] They bionically resemble the ball-and-socket joints found in most tetrapod ...
Canada has a system of analogous rules called the Canada Motor Vehicle Safety Standards (CMVSS), which overlap substantially but not completely in content and structure with the FMVSS. The FMVSS/CMVSS requirements differ significantly from the international UN requirements, so private import of foreign vehicles not originally manufactured to ...
One of those vehicles, a 2009 ES 350, was given as a loaner car to California Highway Patrol officer Mark Saylor on August 28, 2009. Saylor and his wife, daughter, and brother-in-law were driving on State Route 125 in San Diego, California, when their car accelerated out of control and crashed into an embankment , killing everyone in the car.
Without bump-stops, a vehicle that "bottoms out", will experience a very hard shock when the suspension contacts the bottom of the frame or body, which is transferred to the occupants and every connector and weld on the vehicle. Factory vehicles often come with plain rubber "nubs" to absorb the worst of the forces, and insulate the shock.
The terms "active" and "passive" are simple but important terms in the world of automotive safety. "Active safety" is used to refer to technology assisting in the prevention of a crash and "passive safety" to components of the vehicle (primarily airbags, seatbelts and the physical structure of the vehicle) that help to protect occupants during a crash.
Suspension design for other vehicles is similar, though the process may not be as well established. The process entails Selecting appropriate vehicle level targets; Selecting a system architecture; Choosing the location of the 'hard points', or theoretical centres of each ball joint or bushing; Selecting the rates of the bushings
These rods are connected with a socket arrangement similar to a ball joint, called a tie rod end, allowing the linkage to move back and forth freely so that the steering effort will not interfere with the vehicles up-and-down motion as the wheel moves over roads.