When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Pogo pin - Wikipedia

   en.wikipedia.org/wiki/Pogo_pin

   Variety of loose pogo pins and pogo pins in 3-pin assembly holders and with Pick and Place caps Sectional drawing of a pogo pin, showing the plunger, barrel, and spring. A pogo pin or spring-loaded pin is a type of electrical connector mechanism with spring plungers that is used in many modern electronic applications and in the electronics testing industry. [1]

3. Berg connector - Wikipedia

   en.wikipedia.org/wiki/Berg_connector

   This connector has a 2.50 mm (0.098 in) pitch (not 2.54 mm). the two-pin Berg connectors used to connect the front panel lights, turbo switch, and reset button to the motherboard. the two-pin Berg connectors used as jumpers for motherboard configuration.

4. Electrical connector - Wikipedia

   en.wikipedia.org/wiki/Electrical_connector

   Pogo pin connectors. Pogo pin or spring loaded connectors are commonly used in consumer and industrial products, where mechanical resilience and ease of use are priorities. [32] The connector consists of a barrel, a spring, and a plunger. They are in applications such as the MagSafe connector where a quick disconnect is desired for safety.

5. Type 2 connector - Wikipedia

   en.wikipedia.org/wiki/Type_2_connector

   The IEC 62196-2 Type 2 connector (sometimes referred to as Mennekes for the German company that designed it) is used for charging electric vehicles using AC power, mainly within Europe, Australia, NZ and many other countries outside of North America. The Type 2 connector was adopted as the EU standard in 2013, with full compliance required by 2025.

6. IEC 60309 - Wikipedia

   en.wikipedia.org/wiki/IEC_60309

   The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.

7. JST connector - Wikipedia

   en.wikipedia.org/wiki/JST_connector

   It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.