Ads
related to: aftermarket vortec 350 valve covers chevrolet
Search results
Results From The WOW.Com Content Network
1987 – The valve cover surfaces were changed so that the mounting lip was raised and the bolt location was moved from 4 bolts on the perimeter to 4 bolts along the centerline of the valve covers (this design debuted on the Corvette in 1986, and the Chevrolet 4.3L 90 degree V6 the year before). Also changed were the mounting angles of the two ...
The Chevrolet big-block engine is a series of large-displacement, naturally-aspirated, 90°, overhead valve, gasoline-powered, V8 engines that was developed and have been produced by the Chevrolet Division of General Motors from the late 1950s until present. They have powered countless General Motors products, not just Chevrolets, and have been ...
2006 LL8 (Vortec 4200) engine in 2006 Chevrolet TrailBlazer. The LL8 (or Vortec 4200), is a straight-6 gasoline engine produced from 2002 to 2009. It was the first Atlas engine, and was introduced in 2002 for the Chevrolet TrailBlazer, GMC Envoy, and Oldsmobile Bravada. The engine was also used in the Buick Rainier, Saab 9-7X, and Isuzu Ascender.
This was so named because it began with Chevrolet's V8 engines. Chevrolet big-block V8s; Chevrolet small-block V8s; GM Vortec 4300 90° V6; GM Iron Duke RWD inline 4 (early RWD Variants, later versions may use a FWD pattern, and have two possible starter locations) Jeep with GM Iron Duke inline 4 2.5L/151 in 3 (1980-1983).
The Chevrolet small-block engine refers to one of the several gasoline-powered vehicle engines manufactured by General Motors. These include: The first or second generation of non-LS Chevrolet small-block engines; The third, fourth, or fifth generation of LS-based GM engines; The Chevrolet Gemini small-block engine
The High Value engine family from General Motors is a group of cam-in-block or overhead valve V6 engines.These engines feature cast iron blocks and aluminum heads, and use the same 60° vee bank as the 60° V6 family they are based on, but the new 99 mm (3.90 in) bore required offsetting the bores by 1.5 mm (0.059 in) away from the engine center line.