Search results
Results From The WOW.Com Content Network
A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3] [4]
A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four-wheel-drive vehicles.
The Tilting Suspension System [27] (also known as the Leaning Suspension System) is not a different type or geometry of construction; moreover, it is a technology addition to the conventional suspension system. This kind of suspension system mainly consists of independent suspension (e.g., MacPherson strut, A-arm (double wishbone)). With the ...
In the opening paragraph where beam axle suspension is addressed, the article says that the most common multi-link is a 4 link with a panhard rod. While the panhard setup is technicaly a 4 link, almost no where is it actually refered to as such. It is refered to as a three link, with which the panhard bar acts as the fourth restraint.
The 16-valve turbo model's "Dual Mode Suspension" has a dashboard- operated hydraulic actuator built into the front anti-roll bar link, allowing it to toggle between sport and touring modes. [5] The Jeep Wrangler (JK, JL) and Jeep Gladiator (JT) also have a switchable decoupler on Rubicon models, to increase wheel articulation for off-roading.
A swing axle is a simple type of independent suspension designed and patented by Edmund Rumpler in 1903 for the rear axle of rear wheel drive vehicles. This was a revolutionary invention in automotive suspension, allowing driven (powered) wheels to follow uneven road surfaces independently, thus enabling the vehicle's wheels to maintain better ...
Watt's linkage automobile suspension Watt's linkage train suspension. Watt's linkage is used in the rear axle of some car suspensions as an improvement over the Panhard rod, which was designed in the early twentieth century. Both methods are intended to prevent relative sideways motion between the axle and body of the car.
In a solid, "live-axle" suspension system, the rotating inner axle cores (or half-shafts) serve to transmit driving torque to the wheels at each end, while the rigid outer tube maintains the position of the wheels at fixed angles relative to the axle, and controls the angle of the axle and wheels assembly to the vehicle body. The solid axles ...