Search results
Results From The WOW.Com Content Network
The Windows boot manager is located at the \EFI\Microsoft\Boot\ subfolder of the EFI system partition. [23] On Windows XP 64-Bit Edition and later, access to the EFI system partition is obtained by running the mountvol command. Mounts the EFI system partition on the specified drive. Available on Itanium-based computers only. [24]
The system partition and the boot partition (also known as the system volume and the boot volume) are computing terms for disk partitions of a hard disk drive or solid-state drive that must exist and be properly configured for a computer to operate. There are two different definitions for these terms: the common definition and the Microsoft ...
Open Firmware is a standard defining the interfaces of a computer firmware system, formerly endorsed by the Institute of Electrical and Electronics Engineers (IEEE). It originated at Sun Microsystems where it was known as OpenBoot , and has been used by multiple vendors including Sun , Apple , [ 1 ] IBM and ARM .
The Platform Initialization Specification (PI Specification) is a specification published by the Unified EFI Forum that describes the internal interfaces between different parts of computer platform firmware. [1] This allows for more interoperability between firmware components from different sources.
In July 1994, ISI acquired Digital Research's modular real-time multi-tasking operating system FlexOS from Novell. [1] In 1995, ISI offered a pSOSystem/NEST package for Novell Embedded Systems Technology (NEST). [2] [1] In February 2000, ISI was acquired by Wind River Systems, the originators of the rival RTOS VxWorks. Despite initial reports ...
Advanced Configuration and Power Interface (ACPI) is an open standard that operating systems can use to discover and configure computer hardware components, to perform power management (e.g. putting unused hardware components to sleep), auto configuration (e.g. Plug and Play and hot swapping), and status monitoring.
The init system is the first daemon to start (during booting) and the last daemon to terminate (during shutdown). Systemd load's a runlevel target to get the system in working condition (to find the default target, run the command systemctl get-default) [21]. Historically this was the "SysV init", which was just called "init".
LILO (Linux Loader) is a bootloader for Linux and was the default boot loader for most Linux distributions [when?Unlike loadlin, it allowed booting Linux without having DOS on the computer. [3]