When.com Web Search

  1. Ads

    related to: furnace capacitor test with multimeter and tester

Search results

  1. Results From The WOW.Com Content Network
  2. Capacitance meter - Wikipedia

    en.wikipedia.org/wiki/Capacitance_meter

    A capacitance meter is a piece of electronic test equipment used to measure capacitance, [1] mainly of discrete capacitors. Depending on the sophistication of the meter, it may display the capacitance only, or it may also measure a number of other parameters such as leakage , equivalent series resistance (ESR), and inductance .

  3. ESR meter - Wikipedia

    en.wikipedia.org/wiki/ESR_meter

    Measuring ESR can be done by applying an alternating voltage at a frequency at which the capacitor's reactance is negligible, in a voltage divider configuration. It is easy to check ESR well enough for troubleshooting by using an improvised ESR meter comprising a simple square-wave generator and oscilloscope, or a sinewave generator of a few tens of kilohertz and an AC voltmeter, using a known ...

  4. Multimeter - Wikipedia

    en.wikipedia.org/wiki/Multimeter

    Any meter will load the circuit under test to some extent. For example, a multimeter using a moving coil movement with full-scale deflection current of 50 microamps (μA), the highest sensitivity commonly available, must draw at least 50 μA from the circuit under test for the meter to reach the top end of its scale. This may load a high ...

  5. LCR meter - Wikipedia

    en.wikipedia.org/wiki/LCR_meter

    An LCR meter is a type of electronic test equipment used to measure the inductance (L), capacitance (C), and resistance (R) of an electronic component. [1] In the simpler versions of this instrument the impedance was measured internally and converted for display to the corresponding capacitance or inductance value.

  6. In-circuit testing - Wikipedia

    en.wikipedia.org/wiki/In-circuit_testing

    A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.

  7. VLF cable testing - Wikipedia

    en.wikipedia.org/wiki/VLF_cable_testing

    VLF cable testing (Very Low Frequency) is a technique for testing of medium and high voltage (MV and HV) cables. VLF systems are advantageous in that they can be manufactured to be small and lightweight; making them useful – especially for field testing where transport and space can be issues.