Ad
related to: difference between robertson and philips screw sizes diagram worksheet example
Search results
Results From The WOW.Com Content Network
Many screws used in electrical applications (for example, a typical NEMA 5-15R, breaker screws, and conduit screws) use a combination of a slotted/Phillips/Robertson screw head. A few tool manufacturers make bits to engage this screw head better than the traditional Phillips allowing for more torque before camout, for example, the C1 and C2 ...
The Phillips/square screw drive, also known as the Quadrex, Pozisquare screw drive, is a combination of the Phillips and Robertson screw drives. While a standard Phillips or Robertson tool can be used, there is also a dedicated tool for it that increases the surface area between the tool and the fastener so it can handle more torque. [62]
The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...
Robertson, also known as a square, [15] or Scrulox [16] screw drive has a square-shaped socket in the screw head and a square protrusion on the tool. Both the tool and the socket have a taper, which makes inserting the tool easier, and also tends to help keep the screw on the tool tip.
On a shaft, this may be simply a flattened area. A set screw may have any type of drive, such as hex or square head, slot, or recessed --- cross (Phillips), hex (Allen), star (Torx), or square (Robertson). In the UK, the term "set screw" or "setscrew" refers simply to a bolt which is fully threaded, with no smooth shank; called cap screw in the US.
2 Prison screw. 4 comments. 3 PolyDrive. 1 comment. 4 Spline drive. 1 comment. 5 Erroneous? 9 comments. 6 Screw head diagrams. 2 comments. 7 Clutch head bit is not ...
At first, #00 Phillips screws were used, but later iPhone 4 models had pentalobe screws. [9] The screws used were slightly smaller than a Torx TS1, about 0.8 mm. If brought in to an Apple Store for repair, iPhone 4 models with #00 Phillips screws, if any, were replaced with 0.8 mm pentalobe screws. [ 10 ]
However, there is some difference between the two brands. The issue is surrounding the current crop of screws found in switches and receptacles from major building supply stores. You can try slotted, Phillips, or square recess bits on them as they appear to be a combination of those, but they will tend to slip, or cam-out, badly.