Search results
Results From The WOW.Com Content Network
Loopback (also written loop-back) is the routing of electronic signals or digital data streams back to their source without intentional processing or modification.It is primarily a means of testing the communications infrastructure.
Independent Computing Architecture , the Citrix system core protocol; Lightweight Presentation Protocol (LPP) [2] NetWare Core Protocol (NCP) Network Data Representation (NDR) [2] Tox, The Tox protocol is sometimes regarded as part of both the presentation and application layer; eXternal Data Representation (XDR) [2]
Simple Loop Prevention Protocol (SLPP) in computer networking is a data link layer protocol developed by Nortel (previously acquired by Avaya, now a part of Extreme Networks) to protect against Layer 2 network loops. SLPP uses a small hello packet to detect network loops.
IEEE 802.1ag is an amendment to the IEEE 802.1Q networking standard which introduces Connectivity Fault Management (CFM). This defines protocols and practices for the operations, administration, and maintenance (OAM) of paths through 802.1 bridges and local area networks (LANs). The final version was approved by the IEEE in 2007. [1]
The new layer-2 configuration protocols work with backward-compatible extensions to the Ethernet 802.1 frame format; such minimal changes allow AVB devices to coexist and communicate in standard IT networks, however, only AVB-capable switches and endpoint can reserve network resources with admission control and synchronize local time to a ...
In particular, Ethernet operations, administration and maintenance (EOAM) is the protocol for installing, monitoring and troubleshooting Ethernet metropolitan area network (MANs) and Ethernet WANs. The OAM features covered by this protocol are discovery, link monitoring, remote fault detection and remote loopback.
Media Redundancy Protocol (MRP) is a data network protocol standardized by the International Electrotechnical Commission as IEC 62439-2. It allows rings of Ethernet switches to overcome any single failure with recovery time much faster than achievable with Spanning Tree Protocol. [1] It is suitable to most industrial Ethernet applications.
The Microcom Networking Protocols, almost always shortened to MNP, [1] is a family of error-correcting protocols commonly used on early high-speed (2400 bit/s and higher) modems. Originally developed for use on Microcom 's own family of modems, the protocol was later openly licensed and used by most of the modem industry, notably the "big three ...