Ad
related to: does a dipole need balun two
Search results
Results From The WOW.Com Content Network
German physicist Heinrich Hertz first demonstrated the existence of radio waves in 1887 using what we now know as a dipole antenna (with capacitative end-loading). On the other hand, Guglielmo Marconi empirically found that he could just ground the transmitter (or one side of a transmission line, if used) dispensing with one half of the antenna, thus realizing the vertical or monopole antenna.
The balun is a 16:1 ratio, thereby transforming the 50 Ω (ohm) coax to an 800 Ω feed at the antenna. The resistor load is also 800 Ω, non-inductive. This allows the antenna impedance to swing from 400–1,600 Ω over the frequency range intended and thus keep the SWR at the transmitter 2:1 or lower.
A balun / ˈ b æ l ʌ n / (from "balanced to unbalanced", originally, but now derived from "balancing unit") [1] is an electrical device that allows balanced and unbalanced lines to be interfaced without disturbing the impedance arrangement of either line. [2] A balun can take many forms and may include devices that also transform impedances ...
G5RV Antenna without balun. The G5RV antenna is a dipole with a symmetric resonant [ 1 ] feeder line , which serves as impedance matcher for a 50 Ω coax cable to the transceiver . [ 2 ] [ 3 ]
To connect balanced and unbalanced components, a two port device called a balun is used. A balun is a transformer that couples between balanced and unbalanced transmission line components. For example, to feed a dipole antenna from an unbalanced feedline like coaxial cable, the feedline is connected to the antenna through a balun. Without the ...
The monopole antenna is essentially one half of the half-wave dipole, a single 1 / 4 wavelength element with the other side connected to ground or an equivalent ground plane (or counterpoise). Monopoles, which are one-half the size of a dipole, are common for long-wavelength radio signals where a dipole would be impractically large.
Conveniently, the dipole parasitic elements have a node (point of zero RF voltage) at their centre, so they can be attached to a conductive metal support at that point without need of insulation, without disturbing their electrical operation. [4] They are usually bolted or welded to the antenna's central support boom. [4]
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...