Ads
related to: impact wrench for anode removal system for air compressor line dryer
Search results
Results From The WOW.Com Content Network
In 1970, the CP611 impact wrench was used in the steel erection phase of the World Trade Centers (New York City). Sold for several years into industrial markets, CP torque impact wrenches were introduced in the 1970s into the automotive market. In 1987, Chicago Pneumatic became part of the Swedish conglomerate Atlas Copco. During 1988, more new ...
A 1/2" drive pistol-grip air impact wrench. An impact wrench (also known as an impactor, impact gun, air wrench, air gun, rattle gun, torque gun, windy gun) is a socket wrench power tool designed to deliver high torque output with minimal exertion by the user, by storing energy in a rotating mass, then delivering it suddenly to the output shaft ...
[1] [2] Because of this phenomenon, compressed air systems usually benefit from the addition of a compressed air dryer located on the output of the air compressor and/or at various locations throughout the distribution system. In most cases, the output of the compressor is processed through a primary dryer or system dryer.
A pneumatic tool, air tool, air-powered tool or pneumatic-powered tool is a type of power tool, driven by compressed air supplied by an air compressor. Pneumatic tools can also be driven by compressed carbon dioxide (CO 2 ) stored in small cylinders allowing for portability.
An air ratchet wrench is very similar to hand-powered ratchet wrenches in that it has the same square drive, but an air motor is attached to turn the socket drive. Pulling the trigger activates the motor which turns the socket drive. A switch is provided to change which direction the socket drive turns. [1]
Principal view of the pumping action of a twin-screw pump with a six-lobe female screw and a five-lobe male screw. A compressor (as opposed to a pump) would be shaped the same way, except that the shape of the lobes would change along the length of the screw, so that the volume of the trapped pockets would get squeezed smaller as they get closer to the exhaust port.