Ads
related to: 6 3 mc with ground connector plug wire
Search results
Results From The WOW.Com Content Network
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
The MHV connector is typically rated for 1500 VRMS continuous and 5000 V peak, and 3 amperes. With an operating frequency limited to about 300 MHz their usage is restricted to low frequency applications. [2] [3] [4] [1] It was commonly used in laboratory settings for voltages beyond the rating of BNC connectors. Other applications include:
[7] [8] Evaluations at maximum current (3000 A) were conducted with cooling of both the inlet and the connector; for connector cooling only, current was limited to 1000 A, and without cooling, current was limited to 350 A. [9] Versions 2.0 through 2.4 of the MCS connector used "hairpin" shaped contacts, but it was later changed to version 3.0 ...
NEMA L14 are three-pole and ground connectors rated for 125/250 V. Intended for three-pole, four-wire hot-hot-neutral-ground circuits with a nominal supply voltages of 240 or 208 V hot-to-hot and 120 V hot-to-neutral. These connectors are common on household backup generators, and on racks of power amplifiers in large audio systems.
The ground tab is designed to be attached to the outlet faceplate screw, which is supposed to be connected to the building electrical ground. A cheater plug, AC ground lifter or three-prong/two-prong adapter is an adapter that allows a NEMA 5-15P grounding-type plug (three prongs) to connect to a NEMA 1-15R non-grounding receptacle (two slots).
[5] [6] The plug for SAE J560 is physically identical to the connector ISO 1185. The difference is that J560 indicates that the voltage must be 12 V and that wire areas shall be larger due to the higher currents needed when using 12 V compared to 24 V. Some of the pins in the connector have also a slightly different function.