When.com Web Search

  1. Ads

    related to: pump saver and relay switch for well pump

Search results

  1. Results From The WOW.Com Content Network
  2. Dry running protection - Wikipedia

    en.wikipedia.org/wiki/Dry_running_protection

    Dry running protection, also known as dry-run protection or dry-running protection, is a type of protection mechanism to prevent a rotor, pump or stirrer shaft from operating without any medium added, as the bearing and shaft seal might be damaged if the motor is run while dry. [1]

  3. Power system protection - Wikipedia

    en.wikipedia.org/wiki/Power_system_protection

    Switches are safe to open under normal load current (some switches are not safe to operate under normal or abnormal conditions), while protective devices are safe to open under fault current. Very important equipment may have completely redundant and independent protective systems, while a minor branch distribution line may have very simple low ...

  4. Contactor - Wikipedia

    en.wikipedia.org/wiki/Contactor

    AC contactor for pump application. A contactor is an electrically controlled switch used for switching an electrical power circuit. [1] A contactor is typically controlled by a circuit which has a much lower power level than the switched circuit, such as a 24-volt coil electromagnet controlling a 230-volt motor switch.

  5. Safety relay - Wikipedia

    en.wikipedia.org/wiki/Safety_relay

    A normal relay uses a wire coil and the mechanical movement of the metal contacts to switch the load on and off. The metal contacts may weld shut after repeated operation cycles. If this happens, the machine would continue running if the operator pressed the emergency stop pushbutton. This would be hazardous for the operator.

  6. Pressure switch - Wikipedia

    en.wikipedia.org/wiki/Pressure_switch

    Uses of pneumatic pressure switches include: Switch a household well water pump automatically when water is drawn from the pressure tank. Switching off an electrically driven gas compressor when a set pressure is achieved in the reservoir; Switching off a gas compressor, whenever there is no feed in the suction stage. in-cell charge control in ...

  7. Pumpjack - Wikipedia

    en.wikipedia.org/wiki/Pumpjack

    A pumpjack is the overground drive for a reciprocating piston pump in an oil well. [1] It is used to mechanically lift liquid out of the well if there is not enough bottom hole pressure for the liquid to flow all the way to the surface. The arrangement is often used for onshore wells. Pumpjacks are common in oil-rich areas.