Search results
Results From The WOW.Com Content Network
Saltwater is 0.444 psi/ft (2.5% higher than fresh water but this not general and depends on salt concentration in water) Pore pressure in the rock could be as high as 1.0 psi/ft of depth (19.25 lb/gal) A well with 5,000 feet of seawater and 15,000 feet of rock could have an overburden pressures at the bottom as high as 17,220 psi (5000 * 0.444 ...
HSP = 0.052 × MW × TVD', where MW (Mud Weight or density) is the drilling-fluid density in pounds per gallon (ppg), TVD is the true vertical depth in feet and HSP is the hydrostatic pressure in psi. The 0.052 is needed as the conversion factor to psi unit of HSP. [10] [11] To convert these units to SI units, one can use: 1 ppg ≈ 119.826 ...
pound (avoirdupois) per cubic foot lb/ft 3: ≡ lb/ft 3: ≈ 16.018 463 37 kg/m 3: pound (avoirdupois) per cubic inch lb/in 3: ≡ lb/in 3: ≈ 2.767 990 471 × 10 4 kg/m 3: pound (avoirdupois) per gallon (imperial) lb/gal ≡ lb/gal ≈ 99.776 372 66 kg/m 3: pound (avoirdupois) per gallon (US fluid) lb/gal ≡ lb/gal ≈ 119.826 4273 kg/m 3 ...
Converts measurements to other units. Template parameters [Edit template data] This template prefers inline formatting of parameters. Parameter Description Type Status Value 1 The value to convert. Number required From unit 2 The unit for the provided value. Suggested values km2 m2 cm2 mm2 ha sqmi acre sqyd sqft sqin km m cm mm mi yd ft in kg g mg lb oz m/s km/h mph K C F m3 cm3 mm3 L mL cuft ...
In petroleum geology and the petrochemical sciences pertaining to oil wells, and more specifically within hydrostatics, pressure gradients refer to the gradient of vertical pressure in a column of fluid within a wellbore and are generally expressed in pounds per square inch per foot (psi/ft). This column of fluid is subject to the compound ...
The pressure definition differs between sources, but are all close to normal sea level air pressure. A pressure of 14.696 pounds per square inch (1.00000 atm; 101.325 kPa). [2] This is the same pressure as the SI system standard pressure. Gives 1.1953 moles per scf. A pressure of 101.35 kilopascals (1.0002 atm; 14.700 psi). [2]
See WP:MOSNUM#Unit names and the discussion, and see Pound-foot (torque) and Foot-pound (energy). However, some topics use traditional units that conflict with the above convention. To handle these, Module:Convert/makeunits includes a specials table that adds an "alttype" (alternate type) field to certain whitelisted units.
Fluids exert pressure, and this pressure comes from the density and height of the fluid column. Oil companies typically measure density in pounds per gallon (ppg) or kilograms per cubic meter (kg/m 3) and pressure measurement in pounds per square inch (psi) or bar or pascal (Pa). Pressure increases with fluid density.