Search results
Results From The WOW.Com Content Network
In computer networking, a port or port number is a number assigned to uniquely identify a connection endpoint and to direct data to a specific service. At the software level, within an operating system , a port is a logical construct that identifies a specific process or a type of network service .
A VLAN ID is added only if the frame is forwarded out a port configured as a trunk link. If the frame is to be forwarded out a port configured as an access link, the ISL encapsulation is removed. The size of an Ethernet encapsulated ISL frame can be expected to start from 94 bytes and increase up to 1548 bytes because of the overhead ...
A computer port is a hardware piece on a computer where an electrical connector can be plugged to link the device to external devices, such as another computer, a peripheral device or network equipment. [1] This is a non-standard term.
Local Area Transport (LAT) [1] [2] is a non-routable (data link layer) networking technology developed by Digital Equipment Corporation [3] to provide connection between the DECserver terminal servers and Digital's VAX and Alpha and MIPS host computers via Ethernet, giving communication between those hosts and serial devices such as video terminals and printers.
Network-attached storage Hardware / Storage Computer data storage: NAT: Network Address Translation Internet Layer Cisco Internet Protocol Journal: A look Inside Network Address Translators: NBMA: Non-Broadcast Multiple Access (e.g. Frame Relay ATM) Telecom See ATM, Frame Relay and X.25, for examples. NIC: Network Interface Card Physical layer ...
The bridge has three ports. A is connected to bridge port 1, B is connected to bridge port 2, C is connected to bridge port 3. A sends a frame addressed to B to the bridge. The bridge examines the source address of the frame and creates an address and port number entry for host A in its forwarding table. The bridge examines the destination ...
Media Redundancy Protocol (MRP) is a data network protocol standardized by the International Electrotechnical Commission as IEC 62439-2. It allows rings of Ethernet switches to overcome any single failure with recovery time much faster than achievable with Spanning Tree Protocol. [1] It is suitable to most industrial Ethernet applications.
The physical coding sublayer (PCS) is a networking protocol sublayer in the Fast Ethernet, Gigabit Ethernet, and 10 Gigabit Ethernet standards. It resides at the top of the physical layer (PHY), and provides an interface between the physical medium attachment (PMA) sublayer and the media-independent interface (MII).