Search results
Results From The WOW.Com Content Network
Modbus or MODBUS is a client/server data communications protocol in the application layer. [1] It was originally designed for use with programmable logic controllers (PLCs), [2] but has become a de facto standard communication protocol for communication between industrial electronic devices in a wide range of buses and networks.
In AmigaOS one can use the i2c.resource component [25] for AmigaOS 4.x and MorphOS 3.x or the shared library i2c.library by Wilhelm Noeker for older systems. Arduino developers can use the "Wire" library. CircuitPython and MicroPython developers can use the busio.I2C or machine.I2C classes respectively.
The STM32 F7-series is a group of STM32 microcontrollers based on the ARM Cortex-M7F core. Many of the F7 series are pin-to-pin compatible with the STM32 F4-series. Core: ARM Cortex-M7F core at a maximum clock rate of 216 MHz. Many of STM32F76xxx and STM32F77xxx models have a digital filter for sigma-delta modulators (DFSDM) interface. [59]
I3C targets which do not support HDR may then ignore bus traffic until they see a specific "HDR exit" sequence which informs them it is time to listen to the bus again. (One of the I2C Common Command Codes lets the controller ask a target which HDR modes it supports. This is an 8-bit mask, allowing additional HDR modes to be added in future.)
The TMS320 architecture has been around for a while so a number of product variants have developed. The product codes used by Texas Instruments after the first TMS32010 processor have involved a series of processor named "TMS320Cabcd", where a is the main series, b the generation and cd is some custom number for a minor sub-variant.
A controller area network (CAN) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts.
The ARM Cortex-M family are ARM microprocessor cores that are designed for use in microcontrollers, ASICs, ASSPs, FPGAs, and SoCs.Cortex-M cores are commonly used as dedicated microcontroller chips, but also are "hidden" inside of SoC chips as power management controllers, I/O controllers, system controllers, touch screen controllers, smart battery controllers, and sensor controllers.
Before signaling will work, the sender and receiver must agree on the signaling parameters: Full or half-duplex operationThe number of bits per character -- currently almost always 8-bit characters, but historically some transmitters have used a five-bit character code, six-bit character code, or a 7-bit ASCII.