Search results
Results From The WOW.Com Content Network
ISATAP typically builds its Potential Router List (PRL) by consulting the DNS; hence, in the OSI model it is a lower-layer protocol that relies on a higher layer. A circularity is avoided by relying on an IPv4 DNS server, which does not rely on IPv6 routing being established; however, some network specialists claim that these violations lead to insufficient protocol robustness.
IPv6 hosts are required to support multiple addresses per interface; moreover, every IPv6 host is required to configure a link-local address even when global addresses are available. IPv6 hosts may additionally self-configure additional addresses on receipt of router advertisement messages, thus eliminating the need for a DHCP server. [2]
OpenWrt can be configured through either a command-line interface or a web interface called LuCI. OpenWrt provides set of scripts called UCI (unified configuration interface) to unify and simplify configuration through the command-line interface. [66] Additional web interfaces, such as Gargoyle, are also available.
The Neighbor Discovery Protocol (NDP), or simply Neighbor Discovery (ND), is a protocol of the Internet protocol suite used with Internet Protocol Version 6 (IPv6). [1]: §1 It operates at the internet layer of the Internet model, [2] and is responsible for gathering various information required for network communication, including the configuration of local connections and the domain name ...
For IPv6, Path MTU Discovery works by initially assuming the path MTU is the same as the MTU on the link layer interface where the traffic originates. Then, similar to IPv4, any device along the path whose MTU is smaller than the packet will drop the packet and send back an ICMPv6 Packet Too Big (Type 2) message containing its MTU, allowing the ...
IPv6-to-IPv6 Network Prefix Translation (NPTv6) is a specification for IPv6 to achieve address-independence at the network edge, similar to network address translation (NAT) in Internet Protocol version 4 (IPv4).
There is a difference between a "relay router" and a "border router" (also known as a "6to4 border router"). A 6to4 border router is an IPv6 router supporting a 6to4 pseudo-interface. It is normally the border router between an IPv6 site and a wide-area IPv4 network, where the IPv6 site uses 2002:: / 16 co-related to the IPv4 address used later ...
ICMPv6 provides a minimal level of message integrity verification by the inclusion of a 16-bit checksum in its header. The checksum is calculated starting with a pseudo-header of IPv6 header fields according to the IPv6 standard, [6] which consists of the source and destination addresses, the packet length and the next header field, the latter of which is set to the value 58.