When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   One advantage over the Phillips drive is that one driver or bit fits all screw sizes. It is often found in marine hardware and requires a Frearson screwdriver or bit to work properly. The tool recess is a perfect, sharp cross, allowing for higher applied torque, unlike the rounded, tapered Phillips head, which can cam out at high torque. It was ...

3. Hex key - Wikipedia

   en.wikipedia.org/wiki/Hex_key

   The idea of a hex socket screw drive was probably conceived as early as the 1860s to the 1890s, but such screws were probably not manufactured until around 1910. Rybczynski (2000) describes a flurry of patents for alternative drive types in the 1860s to the 1890s in the U.S., [2] which are confirmed to include internal-wrenching square and triangle types (that is, square and triangular sockets ...

4. Computer case screws - Wikipedia

   en.wikipedia.org/wiki/Computer_case_screws

   The hex diameter is 3/16", or 4.7mm. A 5mm hex socket might still fit, however where tightening or removal is required, care needs to be taken to select a nut driver with a sufficiently small outer diameter, as clearance between the jackpost and subminiature connector D-shell is limited.

5. Yankee screwdriver - Wikipedia

   en.wikipedia.org/wiki/Yankee_screwdriver

   The middle size is the No. 30 size, and all numbers with the 30 in them have a chuck shank size of 9/32" (7mm) diameter. The biggest size is the No. 31, and all numbers with 31 in them have a chuck diameter of 5/16" (8mm) diameter. A '1' in front of the number denotes a return spring fitted.

6. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...

7. Preferred metric sizes - Wikipedia

   en.wikipedia.org/wiki/Preferred_metric_sizes

   Machine screws with different thread diameters Hex key set with metric sizes from 2 mm to 10 mm according to sizes for use with ISO 262 screw sizes (except 3.5 mm for M6 internal set screw) For each size bolt or screw and type of head, there is a corresponding size driver prescribed by various ISO standards, including: