Ads
related to: wire lath screws for concrete floors
Search results
Results From The WOW.Com Content Network
Tapcon screws are a popular anchor that stands for self tapping (self threading) concrete screw. Larger diameter screws are referred to as LDT's. This type of fastener requires a pre-drilled hole—using a Tapcon drillbit—and are then screwed into the hole using a standard hex or phillips bit. These screws are often blue, white, or stainless ...
Self-furring lath is an expanded metal lath which is dimpled to hold itself off from a solid surface; Wire lath is made from welded or woven wires and is similar to hardware cloth; Paper backed wire lath is wire lath with building paper attached; Strip laths is metal lath that is several inches wide and is often used to reinforce joints and on ...
Each wall frame is covered in lath, tacked at the studs. Wood lath is typically about one inch (2.5 cm) wide by four feet (1.2 m) long by 1 ⁄ 4 inch (6 mm) thick. Each horizontal course of lath is spaced about 3 ⁄ 8 inch (9.5 mm) away from its neighboring courses. Metal lath is available in 27-inch (69 cm) by 8-foot (240 cm) sheets.
Cellular floor raceways are electrical wiring ducts or cells made from steel floor deck that serve as structural formwork for placement of concrete floor slabs and also as wire and cable raceways within the concrete floor slab.
A wide variety of stucco accessories, such as weep screeds, control and expansion joints, corner-aids and architectural reveals are sometimes also incorporated into the lath. Wire lath is used to give the plaster something to attach to and to add strength. Types include expanded-metal lath, woven-wire lath, and welded-wire lath.
Large load capacity screw piles may have various components such as flat half helices, Bisalloy cutting tips and helices, cap plates or rebar interfaces for connection to various concrete or steel structures. Most industries use screw piling experts due to the cost efficiencies and, increasingly, the reduced environmental impact.