Ads
related to: deutsch connector size chart
Search results
Results From The WOW.Com Content Network
The J1587 protocol uses different diagnostic connectors. Up to 1995, individual OEMs used their own connectors. From 1996 to 2001, the 6-pin Deutsch-connector was standard. Beginning in 2001, most OEMs converted to the 9-pin Deutsch. Some OEMs still use the 6-pin Deutsch. It has mostly been used for US made vehicles, and also by Volvo.
These connectors had the same number of pins as the above DE-15 connectors, but used the more traditional pin size, pin spacing, and size shell of the DA-15 standard connector. "VGA adapters" (i.e. DA-15 to DE-15 dongles) were available but sometimes monitor-specific, or they needed DIP switch configuration, as the Macintosh's monitor sense ...
Deutsch has grown in the last 70+ years and now serves many of the high profile companies like Airbus, Goodrich Corporation, Rolls-Royce plc, Raytheon, Thales Group, Bell, General Dynamics, Ferrari Mazda & Daimler Chrysler Group who rely on these types of connectors to solve many of the engineering problems they encounter when designing future technology.
Five-pin male 180° DIN connector from a 1988 Schneider MF2 keyboard by Cherry. The DIN connector is an electrical signal connector that was standardized by the Deutsches Institut für Normung (DIN), the German Institute for Standards, in the mid 1950s, initially with 3 pins for mono, but when stereo connections and gear appeared in late 1950s (1959 or so), versions with 5 pins or more were ...
Two pin sizes are standard in the jacks for this size plug body, 2.1 mm (0.083 in) and 2.5 mm (0.098 in), and the plugs should match. If the size is not known, it is difficult to distinguish by eye or measurement between the 2.1mm and 2.5mm ID plugs; some suppliers suggest simple methods. [1]
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.