Ad
related to: 8 lug trailer axle capacity manual download free
Search results
Results From The WOW.Com Content Network
Similar to the 11.5 variant, this axle also features a reusable rubber gasket and bears a resemblance to the 11.5 axle in its appearance. Notably, the Ram Power Wagon incorporates this axle type equipped with a locking differential. The 2013 model year marked the final usage of this axle configuration in the Ram 2500 and 3500 trucks.
This can give information about the distribution of axles. For example, provide manufacturers the chassis configuration 8×4×4 to show that the vehicle has two steered front axles and two driven rear axles, compared to the chassis configuration 8×4/4 where the vehicle has one steered front axle, one steered rear axle (the fore axle) and two ...
A tandem axle is defined as two or more consecutive axles whose centers are spaced more than 40 inches (102 cm) but not more than 96 inches (244 cm) apart. [10] Axles spaced less than 40 inches (102 cm) apart are considered a single axle. [11] In effect, the formula reduces the legal weight limit for shorter trucks with fewer axles (see table below
Load capacity is the amount of mass a wheel will carry. This number will vary depending on the number of lugs, the PCD, the material used and the type of axle the wheel is used on. A wheel used on a free rolling trailer axle will carry more weight than that same wheel used on the drive or steering axle of a vehicle.
The 1 + 1 ⁄ 4 ton M880-series was based on the Dodge W200, a 3 ⁄ 4 ton capacity 4×4 civilian/commercial truck. The 880/890 had a 2,500 lb cargo rating, enabling it to have a 5 ⁄ 4-ton load rating. The similar 1 + 1 ⁄ 4 ton M890-series was based on the Dodge D200, a 3 ⁄ 4 ton capacity 4×2 civilian/commercial truck.
The Dana 44 has a GAWR up to 3,500 lb (1,600 kg) and is a semi-floating type, having one bearing on the end of the axle shaft which carries the weight of the vehicle on the axle and also allows axle rotation. There is an 8.9" diameter Dana 44 ring and pinion that is very different from the standard Dana 44.
From 1980 to 1984, the rear axle was typically a Ford 9-inch axle, with the Ford 8.8 axle being phased in gradually; the 9-inch ended production (alongside this generation) in 1986. The F-250 used an 8 lug version of the Dana 44 TTB called the Dana 44 TTBHD with the Dana 50 TTB being an option.
The Ford 8.8 is an automotive axle manufactured by Ford Motor Company at the Sterling Axle Plant in Sterling Heights, MI. It was first used in model year 1983 Ford trucks. The axle was developed to replace the Ford 9-inch axle. This axle is still in production today for a variety of Ford vehicles.