Search results
Results From The WOW.Com Content Network
However, one billion seconds before the 2038 cutoff date is 01:27:28 UTC on 13 May 2006, so requests sent after this time would result in a time-out date which is beyond the cutoff. This made time-out calculations overflow and return dates that were actually in the past, causing software to crash.
computes the difference in seconds between two time_t values time: returns the current time of the system as a time_t value, number of seconds, (which is usually time since an epoch, typically the Unix epoch). The value of the epoch is operating system dependent; 1900 and 1970 are often used. See RFC 868. clock
Unix time numbers are repeated in the second immediately following a positive leap second. The Unix time number 1 483 228 800 is thus ambiguous: it can refer either to start of the leap second (2016-12-31 23:59:60) or the end of it, one second later (2017-01-01 00:00:00). In the theoretical case when a negative leap second occurs, no ambiguity ...
This is a list of the UTC time offsets, showing the difference in hours and minutes from Coordinated Universal Time (UTC), from the westernmost (−12:00) to the easternmost (+14:00). It includes countries and regions that observe them during standard time or year-round.
Metric time is the measure of time intervals using the metric system. The modern SI system defines the second as the base unit of time, and forms multiples and submultiples with metric prefixes such as kiloseconds and milliseconds. Other units of time – minute, hour, and day – are accepted for use with SI, but are not part of it
Hexadecimal time is the representation of the time of day as a hexadecimal number in the interval [0, 1). The day is divided into 10 16 (16 10 ) hexadecimal hours, each hour into 100 16 (256 10 ) hexadecimal minutes, and each minute into 10 16 (16 10 ) hexadecimal seconds.
The fraction of the day is found by converting the number of hours, minutes, and seconds after noon into the equivalent decimal fraction. Time intervals calculated from differences of Julian Dates specified in non-uniform time scales, such as UTC, may need to be corrected for changes in time scales (e.g. leap seconds). [8]
[17] The separator used between date values (year, month, week, and day) is the hyphen, while the colon is used as the separator between time values (hours, minutes, and seconds). For example, the 6th day of the 1st month of the year 2009 may be written as "2009-01-06" in the extended format or as "20090106" in the basic format without ambiguity.