When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Batten - Wikipedia

   en.wikipedia.org/wiki/Batten

   Batten trim or batten molding is a thin strip of trim typically with a rectangular cross-section similar to lath used in lattice, used to cover seams between panels of exterior siding or interior paneling.

3. The Crane Group Companies - Wikipedia

   en.wikipedia.org/wiki/The_Crane_Group_Companies

   Products include wood composite decking and railing, exterior cladding products, vinyl fencing, OEM PVC profiles, wood doors and door-frames, and vinyl sheet piling. The group also has several service units in the roofing, security gate systems, and steel I-beam markets.

4. Lath and plaster - Wikipedia

   en.wikipedia.org/wiki/Lath_and_plaster

   Metal lathing was spaced across a 13.5-inch (340 mm) center, attached by tie wires using lathers' nippers. Sometimes, the mesh was dimpled to be self- furring . In use as early as 1900, rock lath (also known as "button board," "plaster board" or "gypsum-board lath"), is a type of gypsum wall board (essentially an early form of drywall) with ...

5. Core Molding Technologies - Wikipedia

   en.wikipedia.org/wiki/Core_Molding_Technologies

   Core Molding Technologies, Inc. was founded in 1988 (its original name was Core Materials Corporation) and now based in Columbus, Ohio. The company manufactures sheet molding compounds (SMC), and molds fiberglass reinforced plastics .

6. Framing (construction) - Wikipedia

   en.wikipedia.org/wiki/Framing_(construction)

   Studs usually consist of 1 + 1 ⁄ 2-by-3 + 1 ⁄ 2-inch (38 mm × 89 mm) or 1 + 1 ⁄ 2-by-5 + 1 ⁄ 2-inch (38 mm × 140 mm) lumber and are commonly spaced at 16 inches (410 mm) on center. This spacing may be changed to 12 or 24 inches (300 or 610 mm) on center depending on the load and the limitations imposed by the type and thickness of the ...

7. Shell molding - Wikipedia

   en.wikipedia.org/wiki/Shell_molding

   Shell molding was developed as a manufacturing process during the mid-20th century in Germany. It was invented by German engineer Johannes Croning. [3] [4] Shell mold casting is a metal casting process similar to sand casting, in that molten metal is poured into an expendable mold. However, in shell mold casting, the mold is a thin-walled shell ...