Ads
related to: acrylic thickness calculator
Search results
Results From The WOW.Com Content Network
Coating material (after curing) should have a thickness of 30–130 μm (0.0012–0.0051 in) when using acrylic resin, epoxy resin, or urethane resin. For silicone resin, the coating thickness recommended by the IPC standards is 50–210 μm (0.0020–0.0083 in).
Acrylic elastomer is a general term for a type of synthetic rubber whose primary component is acrylic acid alkyl ester (ethyl or butyl ester). [3] Acrylic elastomer possesses characteristics of heat and oil resistance, with the ability to withstand temperatures of 170–180 °C. It is used primarily for producing oil seals and packaging related ...
From acrylic, it obtains rigidity and formability; from PVC, toughness, chemical resistance and good interior finish ratings. Sheet thickness ranges from .029 to .500 inches (0.74 to 12.70 mm) and can be thermoformed, post formed, brake formed and laminated. [2] Flexural modulus is 2,800 megapascals (400,000 psi)
PMMA transmits up to 92% of visible light (3 mm (0.12 in) thickness), [18] and gives a reflection of about 4% from each of its surfaces due to its refractive index (1.4905 at 589.3 nm). [3] It filters ultraviolet (UV) light at wavelengths below about 300 nm (similar to ordinary window glass).
A material's half-value layer (HVL), or half-value thickness, is the thickness of the material at which the intensity of radiation entering it is reduced by one half. [1] HVL can also be expressed in terms of air kerma rate (AKR), rather than intensity: the half-value layer is the thickness of specified material that, "attenuates the beam of radiation to an extent such that the AKR is reduced ...
In most of the cases, 10% amounts of other vinyl comonomers are also used (1–10%) along with AN depending on the final application. Comonomers include acrylic acid, acrylamide, allyl compounds, and sulfonated styrene. [2] Anionic polymerization also can be used for synthesizing PAN.