Search results
Results From The WOW.Com Content Network
Control theory is a field of control engineering and applied mathematics that deals with the control of ... peak overshoot (the ... backstepping, sliding mode control
The flyback converter is an isolated power converter. The two prevailing control schemes are voltage mode control and current mode control. In the majority of cases current mode control needs to be dominant for stability during operation. Both modes require a signal related to the output voltage. There are three common ways to generate this ...
By integrating Idt (= dQ ; as I = dQ/dt, C = Q/V so dV = dQ/C) under the output current waveform through writing output ripple voltage as dV = Idt/C we integrate the area above the axis to get the peak-to-peak ripple voltage as: ΔV = ΔI T/8C (where ΔI is the peak-to-peak ripple current and T is the time period of ripple. A full explanation ...
Large current when mains-powered linear power supply equipment is switched on until magnetic flux of transformer stabilizes and capacitors charge completely, unless a slow-start circuit is used. Extremely large peak "in-rush" surge current limited only by the impedance of the input supply and any series resistance to the filter capacitors.
Pressure control provided only a proportional control that, if the control gain was too high, would become unstable and go into overshoot with considerable instability of depth-holding. The pendulum added what is now known as derivative control, which damped the oscillations by detecting the torpedo dive/climb angle and thereby the rate-of ...
In analog control, the control signal is typically an electrical voltage or current (although other signals such as hydraulic pressure can be used). In this case a lead-lag compensator will consist of a network of operational amplifiers ("op-amps") connected as integrators and weighted adders. A possible physical realization of a lead-lag ...
Marion King Hubbert accurately predicted a peak in U.S. oil production in 1956, in the first widely published peak oil theory. Since then, people have been predicting when demand would exceed supply.
When directly connecting a load to cell, the operating point of the panel is rarely at peak power. The impedance seen by the panel determines its operating point. Setting the impedance correctly achieves peak power. Since panels are DC devices, DC-DC converters transform the impedance of one circuit (source) to the other circuit (load ...