Ads
related to: 34 pin floppy disk connector for sale
Search results
Results From The WOW.Com Content Network
The de facto standard for 3.5 inch drives uses a 34-pin header mating to an IDC Berg connector, collectively slightly smaller than the PCB edge pin connector and mating socket used for the 5¼ inch standard but with the same 34 pin definitions as the 5¼ inch standard. [7] A separate connector is provided for DC power. [1]
A 34-pin control cable and a 20-pin data cable for an ST-412 drive connected to a controller card. A 4-pin Molex connector supplying power to the drive can not be seen in this image. In the ST-506 interface, the drive connects to a controller card with two ribbon cables carrying signals, while a third cable provides power.
Many types of Berg connectors exist. Some of the more familiar ones used in IBM PC compatibles are: the four-pin polarized Berg connectors used to connect 3½-inch floppy disk drive units to the power supply unit, usually referred to as simply a "floppy power connector", but often also referred to as LP4. This connector has a 2.50 mm (0.098 in ...
When the controller and disk drive are assembled as one device, as it is the case with some external floppy disk drives, e.g., Commodore 1540 and USB floppy disk drives, [27] the internal floppy disk drive and its interface are unchanged, while the assembled device presents a different interface such as IEEE-488, parallel port or USB.
Enhanced Small Disk Interface (ESDI) is a hard disk drive interface designed by Maxtor Corporation in 1983 to be a follow-on to the ST-412/506 interface. [1] ESDI improved on ST-506 by moving certain parts that were traditionally kept on the controller (such as the data separator) into the drives themselves, and also generalizing the control bus such that more kinds of devices (such as ...
It is attached normally on the black (master drive end) and blue (motherboard end) connectors. This enables cable select functionality. Pin 34 Pin 34 is connected to ground inside the blue connector of an 80-conductor cable but not attached to any conductor of the cable, allowing for detection of such a cable.
The IIc has a built-in floppy disk drive and a keyboard, and was often sold with its matching monitor. The c in the name stands for compact, referring to the fact it is a complete Apple II setup in a smaller notebook-sized housing. It is compatible with a wide range of Apple II software and peripherals.
The floppy disk drives on these models were in the unusual 3-inch "compact floppy" format, [13] which was selected as it had a simpler electrical interface than 3½-inch drives. [33] In the range's early days supplies of 3-inch floppies occasionally ran out, [13] but by 1988 the PCW's popularity encouraged suppliers to compete for this market. [34]