Ads
related to: semi landing gear
Search results
Results From The WOW.Com Content Network
These are typically used on the rear axle or wheels of vehicles, but also found in both front and main landing gear of aircraft. A "semi trailing-arm" (or semi trailing-link) is a common form of independent rear suspension on automobiles, particularly those with front wheel drive (where it allows a flatter rear floor pan).
The landing gear represents 2.5 to 5% of the maximum takeoff weight (MTOW) and 1.5 to 1.75% of the aircraft cost, but 20% of the airframe direct maintenance cost. A suitably-designed wheel can support 30 t (66,000 lb), tolerate a ground speed of 300 km/h and roll a distance of 500,000 km (310,000 mi) ; it has a 20,000 hours time between overhaul and a 60,000 hours or 20 year life time.
A semi-trailer is a trailer without a ... Some low-set trailers such as lowboys/low-loaders and car transporters have electrically powered landing gear due to the ...
A Boeing 747-400's main landing gear. Note the toes-up bias angle of the bogies on the wing gear, to ensure correct stowage upon retraction: 707, 720, 757, 767, 787: 10 wheels [1x2]+[2x4] A Boeing 757-200 from British Airways: 777: 14 wheels [1x2]+[2x6] A Boeing 777-200 from United Airlines.
[1] [2] Another borrowed term is "landing gear" (from the aviation industry), which refers to the legs which support the front end of a semi-trailer when it is not connected to a semi-truck. Some nicknames are obvious wordplay, such as "portable parking lot", in reference to a truck that carries automobiles.
A small number of older aircraft (including the Mooney M-18, some older M20s and some Progressive Aerodyne SeaReys) also have landing gear actuated by Johnson bars. The Boeing 707/720 aircraft had a Johnson bar for manually extending the nose landing gear, in case the normal gear extension failed. [citation needed]
Pages in category "Aircraft with fixed conventional landing gear" The following 200 pages are in this category, out of approximately 1,308 total. This list may not reflect recent changes .
In trucking, a bogie is the subassembly of axles and wheels that supports a semi-trailer, whether permanently attached to the frame (as on a single trailer) or making up the dolly that can be hitched and unhitched as needed when hitching up a second or third semi-trailer (as when pulling doubles or triples).