When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Wrightsoft - Wikipedia

   en.wikipedia.org/wiki/Wrightsoft

   Wrightsoft is a software development firm for heating, ventilation, and air conditioning . Established in 1985, [1] Wrightsoft has served residential, commercial, and educational markets by providing HVAC design, specification, and sales software. [2] Wrightsoft is headquartered in Lexington, Massachusetts, USA.

3. Cooling load temperature difference calculation method

   en.wikipedia.org/wiki/Cooling_load_temperature...

   The CLTD/CLF/SCL (cooling load temperature difference/cooling load factor/solar cooling load factor) cooling load calculation method was first introduced in the 1979 ASHRAE Cooling and Heating Load Manual (GRP-158) [1] The CLTD/CLF/SCL Method is regarded as a reasonably accurate approximation of the total heat gains through a building envelope ...

4. Process duct work - Wikipedia

   en.wikipedia.org/wiki/Process_Duct_Work

   Duct plate 3/16", or thinner, may dishpan, or make noise, and should be avoided. Rectangular duct section properties are calculated from the distance between the upper to lower duct corners of the ductwork The flanges areas are based on the size of corner angles plus duct plate width based on the plate thickness ratio of 16*t.

5. Friction loss - Wikipedia

   en.wikipedia.org/wiki/Friction_loss

   Note that, in approximation, for a given value of flow volume, a step up in duct size (say from 100mm to 120mm) will reduce the friction loss by a factor of 3. Volumetric Flow Q of air at STP where friction loss per unit length Δ p / L (SI kg / m 2 / s 2 ) is, resp., 0.082, 0.245, and 0.816., for selected Nominal Duct Sizes [ 19 ] in smooth ...

6. Heating, ventilation, and air conditioning - Wikipedia

   en.wikipedia.org/wiki/Heating,_ventilation,_and...

   Rooftop HVAC unit with view of fresh-air intake vent Ventilation duct with outlet diffuser vent. These are installed throughout a building to move air in or out of rooms. In the middle is a damper to open and close the vent to allow more or less air to enter the space.

7. Underfloor air distribution - Wikipedia

   en.wikipedia.org/wiki/Underfloor_air_distribution

   While overhead systems typically use ducts to distribute the air, UFAD systems use the underfloor plenum formed by installation of a raised floor. The plenum generally sits 0.3 and 0.46 metres (12 and 18 in) above the structural concrete slab, although lower heights are possible.