Search results
Results From The WOW.Com Content Network
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
A null modem adapter. Null modem is a communication method to directly connect two DTEs (computer, terminal, printer, etc.) using an RS-232 serial cable.The name stems from the historical use of RS-232 cables to connect two teleprinter devices or two modems in order to communicate with one another; null modem communication refers to using a crossed-over RS-232 cable to connect the teleprinters ...
Serial cables are typically used for RS-232 communication. A serial cable or RS-232 cable is a cable used to transfer information between two devices using a serial communication protocol. The form of connectors depends on the particular serial port used. A cable wired for connecting two DTEs directly is known as a null modem cable.
This connector has been standardized for RS-232 as TIA-574. Some miniaturized electronics, particularly graphing calculators [5] and hand-held amateur and two-way radio equipment, [6] have serial ports using a phone connector, usually the smaller 2.5 or 3.5 mm connectors and the most basic 3-wire interface—transmit, receive and ground.
Diagram of RS232 signalling as seen when probed by an Oscilloscope for an uppercase ASCII "K" character (0x4b) with 1 start bit, 8 data bits, 1 stop bit: Date: 6 March 2009, 10:25 (UTC) Source: Rs232_oscilloscope_trace.jpg; Author: Rs232_oscilloscope_trace.jpg: Ktnbn; derivative work: Samuel Tardieu (talk) Other versions
This cabling system was invented to eliminate the differences in RS-232 wiring systems. Any two RS-232 systems can be directly connected by a standard rollover cable and a standard connector. For legacy equipment, an adapter is permanently attached to the legacy port.
The electric signaling levels are handled by a driver circuit external to the UART. Common signal levels are RS-232, RS-485, and raw TTL [1] for short debugging links. Early teletypewriters used current loops. It was one of the earliest computer communication devices, used to attach teletypewriters for an operator console.
Data Terminal Ready (DTR) is a control signal in RS-232 serial communications, transmitted from data terminal equipment (DTE), such as a computer, to data communications equipment (DCE), for example a modem, to indicate that the terminal is ready for communications and the modem may initiate a communications channel.