Ads
related to: what speed can cat5 handle- Cat6 Patch Cables
Quantity Discounts as low as $2.13
All Colors and Lengths.
- Bulk Cable
Buy network, telephone, coax, audio
& video cables and wire in bulk!
- Network Cables
Custom Lengths and Colors
In Stock. Same Day Shipping!
- HDMI Cables
High Speed & Enhanced Ethernet.
Offered in 1ft-65ft Options.
- Cat6 Patch Cables
Search results
Results From The WOW.Com Content Network
Category 5 cable that is partially stripped and showing its four twisted pairs (eight wires). Category 5 cable (Cat 5) is a twisted pair cable for computer networks.Since 2001, the variant commonly in use is the Category 5e specification (Cat 5e).
This is a list of interface bit rates, is a measure of information transfer rates, or digital bandwidth capacity, at which digital interfaces in a computer or network can communicate over various kinds of buses and channels. The distinction can be arbitrary between a computer bus, often closer in space, and larger telecommunications networks.
Ethernet over twisted-pair technologies use twisted-pair cables for the physical layer of an Ethernet computer network. They are a subset of all Ethernet physical layers . Early Ethernet used various grades of coaxial cable , but in 1984, StarLAN showed the potential of simple unshielded twisted pair .
Generally, layers are named by their specifications: [8] 10, 100, 1000, 10G, ... – the nominal, usable speed at the top of the physical layer (no suffix = megabit/s, G = gigabit/s), excluding line codes but including other physical layer overhead (preamble, SFD, IPG); some WAN PHYs (W) run at slightly reduced bitrates for compatibility reasons; encoded PHY sublayers usually run at higher ...
Standards-based Power over Ethernet is implemented following the specifications in IEEE 802.3af-2003 (which was later incorporated as Clause 33 into IEEE 802.3-2005) or the 2009 update, IEEE 802.3at. The standards require Category 5 cable or better for high power levels but allow using Category 3 cable if less power is required. [27]
By reducing the original signal rate to 1 ⁄ 4 or 1 ⁄ 2, the link speed drops to 2.5 or 5 Gbit/s, respectively. [5] The spectral bandwidth of the signal is reduced accordingly, lowering the requirements on the cabling, so that 2.5GBASE-T and 5GBASE-T can be deployed at a cable length of up to 100 m on Cat 5e or better cables. [6] [7]