Search results
Results From The WOW.Com Content Network
A feature's orientation can also be represented by dip and dip direction, using the azimuth of the dip rather than the strike value. Linear features are similarly measured with trend and plunge, where "trend" is analogous to dip direction and "plunge" is the dip angle. [3] Strike and dip are measured using a compass and a clinometer. A compass ...
The three-dimensional orientation of a line can be described with just a plunge and trend. The rake is a useful description of a line because often (in geology) features (lines) follow along a planar surface. In these cases the rake can be used to describe the line's orientation in three dimensions relative to that planar surface.
For example, a dip of 45 degrees towards 115 degrees azimuth, recorded as 45/115. Note that this is the same as above. The term hade is occasionally used and is the deviation of a plane from vertical i.e. (90°-dip). Fold axis plunge is measured in dip and dip direction (strictly, plunge and azimuth of plunge).
The arrow is oriented in the downgoing direction of the linear feature (the "trend") and at the end of the arrow, the number of degrees that the feature lies below the horizontal (the "plunge") is noted. Trend and plunge are often notated as PLUNGE → TREND (for example: 34 → 86 indicates a feature that is angled at 34 degrees below the ...
Lineations in structural geology are linear structural features within rocks. [1] There are several types of lineations, intersection lineations, crenulation lineations, mineral lineations and stretching lineations being the most common. Lineation field measurements are recorded as map lines with a plunge angle and azimuth.
Dip is defined as the angle of the fault relative to the surface of the earth, which indicates the plane on which slip will occur. Lastly, in any non-vertical fault, the block above the fault is called the hanging wall, while the block below the fault is called the footwall. [4] Normal and reverse dip-slip faults with labeled hanging wall and ...
Dip separation can also occur when motion of the fault is perpendicular to the fault trace. That is, the fault blocks are pulled away from each other or pushed towards each other. This is known as a dip-slip fault. This causes vertical separation between the blocks as one is dropped down in the space created by extensional forces, or one block ...
Cross-bedding – the axis of a trough cross bed or the down-dip direction of a tabular cross bed point the direction of paleo flow. Current ripple marks – will have the short side of the ripple pointing down stream. Sole markings/flute casts – the short, steep side will point up stream, and the long, tapered side points down stream.