Search results
Results From The WOW.Com Content Network
A quarter panel is typically a welded-on component of the unibody structure. Replacement of a sheet metal quarter panel typically requires it to be cut off the vehicle and a replacement part to be welded (or sometimes bonded) to the vehicle. Due to the high amount of specialized labor, a quarter panel may often be repaired rather than replaced ...
The fourth-generation Chevrolet Camaro is a pony car that was produced by American automobile manufacturer General Motors for the 1993 through 2002 model years. It was introduced on an updated F-body platform but retained the same characteristic since the first-generation's introduction back in 1967: two doors, coupe or convertible bodystyles, rear-wheel drive, and a choice of 6-cylinder and ...
Quarter glass (or quarter light) on automobiles and closed carriages may be a side window in the front door or located on each side of the car just forward of the rear-facing rear window of the vehicle. [1] Only some cars have them. In some cases, the fixed quarter glass may set in the corner or "C-pillar" of the vehicle.
Work Completed: Replaced gear knob, passenger door and door mirrors, pulled and filled dent in rear nearside quarter panel, repainted wheels and replaced the centre caps, applied new door sill decals, replaced handbrake lever, replaced handbrake warning light, adjusted rear exhaust section to prevent it from knocking against the undercarriage, fitted a new stereo, engine service including ...
The Oshawa Car Assembly plant in the city of Oshawa, Ontario, Canada, began producing the new Camaro [21] which went on sale in spring of 2009 as a 2010 model year vehicle. [ 22 ] [ 23 ] The new body used styling cues from the 1969 Camaro, including the grille, roof styling, quarter windows, and side trim.
A total of 250 black and 250 red examples were produced. They were all equipped with the 5.0 TPI LB9 engine and TH700-R4 automatic transmission. All came equipped with the IROC-Z fog lights, wheels and ground effects, but with the base Camaro's hood (no louvers), rear decklid (no spoiler), and no exterior decals.
New door skins, rear quarter panels, and rear valance panel made the car look lower and wider. This styling would only serve for the 1969 model year . To increase competitiveness in the SCCA Trans-Am racing series, optional four-wheel disc brakes with four-piston calipers were made available during the year, under RPO JL8, for US$500.30. [ 23 ]
Quarter-panel (or rear quarter panel) refers to the panel at the back sides starting at the rear edge of the rearmost doors, bordered by at top by the trunk (boot) lid and at bottom by the rear wheel arches ending at the rear bumper. This is the opposite of the fender. Literally, the term originally referred to the rear quarter or the car's length.