Ads
related to: are obd ports universal c a 1 6 3
Search results
Results From The WOW.Com Content Network
OBD 1.5 refers to a partial implementation of OBD-II which General Motors used on some vehicles in 1994, 1995 & 1996 (GM did not use the term OBD 1.5 in the documentation for these vehicles — they simply had an OBD and an OBD-II section in the service manual).
The data link connector (DLC) is the multi-pin diagnostic connection port for automobiles, trucks, and motorcycles used to interface a scan tool with the control modules of a given vehicle and access on-board diagnostics and live data streams. [1] Prior to 1996, many OBD-I data link connector's were in the engine compartment, usually near the ...
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections .
Unified Diagnostic Services (UDS) is a diagnostic communication protocol used in electronic control units (ECUs) within automotive electronics, which is specified in the ISO 14229-1. [1] It is derived from ISO 14230-3 and the now obsolete ISO 15765-3 (Diagnostic Communication over Controller Area Network (DoCAN) [2]). 'Unified' in this context ...
Some 160 baud models constantly transmitted sensor data on startup, while others started transmitting data when placed in diagnostic mode with a resistor connected to the ALDL port. Later versions were bidirectional and operated at a much faster (but incredibly slow compared to today's standards) rate of 8192 baud.
A controller area network (CAN) is a vehicle bus standard designed to enable efficient communication primarily between electronic control units (ECUs). Originally developed to reduce the complexity and cost of electrical wiring in automobiles through multiplexing, the CAN bus protocol has since been adopted in various other contexts.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A passthrough device is a device used in conjunction with a computer to reprogram vehicle control modules through the OBD-II/CANbus port. [1] Each manufacturer has their own type, but SAE International standardized the J-2534 universal requirements in 2004, requiring all manufacturers to allow vehicles sold in the United States of America and Europe to accept powertrain reprogramming through ...