Search results
Results From The WOW.Com Content Network
Copper has a very linear resistance–temperature relationship; however, copper oxidizes at moderate temperatures and cannot be used over 150 °C (302 °F). [citation needed] The significant characteristic of metals used as resistive elements is the linear approximation of the resistance versus temperature relationship between 0 and 100 °C.
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...
For instance, setting those up so that the temperature in the morning at 7 a.m. should be 21 °C (69.8 °F), makes sure that at that time the temperature will be 21 °C (69.8 °F), where a conventional thermostat would just start working at that time.
The SI unit of absolute thermal resistance is kelvins per watt (K/W) or the equivalent degrees Celsius per watt (°C/W) – the two are the same since the intervals are equal: ΔT = 1 K = 1 °C. The thermal resistance of materials is of great interest to electronic engineers because most electrical components generate heat and need to be cooled.
The Resistance Temperature Detector is nearly always refered to in industry as an RTD - many folk don't even know it is an acronym. Resistance thermometer is an equivalent name for the same device. Converting the two into a common reference makes good sense. These are very commonly used for industrial temperature measurements.
Resistance temperature detector. Add languages. Add links. Article; ... Download QR code; Print/export Download as PDF; Printable version;
If the resistance of the absorbing element depends on the electron temperature, then the resistance can be used as a thermometer of the electron system. This is the case for both semiconducting and superconducting materials at low temperature. If the absorbing element does not have a temperature-dependent resistance, as is typical of normal ...
Thermistor – Resistor whose resistance changes with temperature, up PTC or down NTC; Resistance Temperature Detector (RTD) – Wire whose resistance changes with temperature; Bolometer – Device for measuring the power of incident electromagnetic radiation; Thermal cutoff – Switch that is opened or closed when a set temperature is exceeded