Ads
related to: 4afe timing belt interference engine help with bad transmission damage
Search results
Results From The WOW.Com Content Network
A pair of poppet valves bent by collision with a piston after timing belt failure. The engine was running at 4500 RPM. In interference engine designs, replacing a timing belt in regular intervals (manufacturers recommend intervals ranging from 60,000 to 104,000 miles) or repairing chain issues as soon as they are discovered is essential, as incorrect timing may result in the pistons and valves ...
Another cause for timing belt failure is improperly adjusting the timing belt on engines with a manual tensioner (1989 to very early 1990 models only) or improperly adjusting the balance shaft belt. Because this is an interference engine, damage will occur if the timing belt fails. Another common occurrence is that the balance shaft's oil seals ...
A timing belt is used to drive the valvetrain. Early production 2.0 L engines used a hydraulic tensioner to tension the timing belt. 2000 and 2001 engines used a mechanical spring-loaded tensioner that tended to wear out prematurely, causing serious valve and piston damage upon belt failure due to the interference design of the engine. 2002 and ...
One critical maintenance issue specific to the Yugo 55 and 65 (the 45 was a 903 cc pushrod engine, with a timing chain) [39] was the need for regular replacement of the interference engine's timing belt — every 40,000 miles (64,000 km). [38] In a non-interference engine, timing belt failure does not cause further damage to the engine.
Initially belt-driven OHC non-interference engines (except the VVT-i version which is an interference engine), multivalve DOHC (except the 1G-EU SOHC 12 valve engine) and variable valve timing were added later during the production run. The 1G-GEU was Toyota's first mass produced four-valve twincam engine. [1]
The 3S-FE engine is fitted with a cast iron crankshaft, whereas the 3S-GE/GELU engines have forged crankshafts. [11] The 3S-FSE was a direct injection engine with Toyota D4 system. A cam driven high pressure fuel pump is at the #4 end of the head. This engine was only released in Japan, and installed in the Camry (Windom).
The Toyota E engine family is a straight-four piston engine series, and uses timing belts rather than chains. The E engines were the first multi-valve engines from Toyota designed with economy, practicality and everyday use in mind (rather than performance). Like many other Toyota engines from the era, the E engine series features a cast iron ...
The 1962 Glas 1004 was the first mass-produced vehicle to use a timing belt. The 1966 Pontiac OHC Six engine was the first US mass-produced vehicle to use a timing belt, [21] [22] while the 1966 Fiat Twin Cam engine was the first mass-produced engine to use a timing belt with twin camshafts. Carmakers began to adopt timing belts in the 1970s ...